あなたは350-401認証試験試験に参加する予定があると、弊社の無料な試用版の350-401認証試験問題と回答を使用してみることができます。それでは、この問題集はあなたに適用するかどうかを確認した後、購入することを決定します。Goldmile-Infobiz 350-401認証試験問題集を使って試験に合格しない場合に、当社は全額返金できます。 すると、Ciscoの350-401認証試験試験に合格する実力を持つようになりました。Goldmile-InfobizのCiscoの350-401認証試験試験トレーニング資料を持つことは明るい未来を持つことと同じです。 弊社の350-401認証試験試験問題集によって、あなたの心と精神の満足度を向上させながら、勉強した後350-401認証試験試験資格認定書を受け取って努力する人生はすばらしいことであると認識られます。
350-401認証試験練習資料が最も全面的な参考書です。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)認証試験認定試験の準備をするために、Goldmile-Infobiz の専門家たちは彼らの豊富な知識と実践を生かして特別なトレーニング資料を研究しました。 今競争の激しいIT業界で地位を固めたいですが、Cisco 350-401 受験資格認証試験に合格しなければなりません。IT業界ではさらに強くなるために強い専門知識が必要です。
Goldmile-Infobizは実践の検査に合格したもので、Goldmile-Infobizの広がりがみんなに大きな利便性と適用性をもたらしたからです。Goldmile-Infobizが提供したCiscoの350-401認証試験試験資料はみんなに知られているものですから、試験に受かる自信がないあなたはGoldmile-InfobizのCiscoの350-401認証試験試験トレーニング資料を利用しなければならないですよ。Goldmile-Infobizを利用したら、あなたはぜひ自信に満ちているようになり、これこそは試験の準備をするということを感じます。
Cisco 350-401認証試験 - もし失敗だったら、我々は全額で返金します。
Goldmile-Infobizの350-401認証試験問題集というものをきっと聞いたことがあるでしょう。でも、利用したことがありますか。「Goldmile-Infobizの350-401認証試験問題集は本当に良い教材です。おかげで試験に合格しました。」という声がよく聞こえています。Goldmile-Infobizは問題集を利用したことがある多くの人々からいろいろな好評を得ました。それはGoldmile-Infobizはたしかに受験生の皆さんを大量な時間を節約させ、順調に試験に合格させることができますから。
Goldmile-InfobizのCiscoの350-401認証試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料はIT職員としてのあなたがIT試験に受かる不可欠なトレーニング資料です。Goldmile-InfobizのCiscoの350-401認証試験試験トレーニング資料はカバー率が高くて、更新のスピードも速くて、完全なトレーニング資料ですから、Goldmile-Infobiz を手に入れたら、全てのIT認証が恐くなくなります。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
それはきっと君のCiscoのHuawei H28-315_V1.0試験に合格することの良い参考資料です。 これは間違いなくあなたがScrum SAFe-Practitioner認定試験に合格することを保証できる問題集です。 ２１世紀の情報時代の到着に伴い、CiscoのHuawei H19-495_V1.0試験の認定はIT業種で不可欠な認定になっています。 IT職員の皆さんにとって、この試験のAmazon SOA-C02-JPN認証資格を持っていないならちょっと大変ですね。 SAP C_ARP2P_2508 - あなたはGoldmile-Infobizの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。
Updated: May 28, 2022