これは受験生の皆さんが資料を利用した後の結果です。Goldmile-InfobizのCiscoの350-401復習解答例試験トレーニング資料を選んだら、１００パーセントの成功率を保証します。もし失敗だったら、我々は全額で返金します。 おそらく、君たちは私たちの350-401復習解答例試験資料について何も知らないかもしれません。でも、私たちの350-401復習解答例試験資料のデモをダウンロードしてみると、全部わかるようになります。 Goldmile-InfobizのCiscoの350-401復習解答例「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料はIT職員としてのあなたがIT試験に受かる不可欠なトレーニング資料です。
CCNP Enterprise 350-401 君の夢は1歩更に近くなります。
なぜかと言うと、もちろん350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)復習解答例認定試験がとても大切な試験ですから。 Goldmile-Infobizの助けのもとで君は大量のお金と時間を费やさなくても復楽にCiscoの350-401 科目対策認定試験に合格のは大丈夫でしょう。ソフトの問題集はGoldmile-Infobizが実際問題によって、テストの問題と解答を分析して出来上がりました。
認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoの350-401復習解答例試験を研究していて、最新のCiscoの350-401復習解答例問題集を提供します。ですから、君はうちの学習教材を安心で使って、きみの認定試験に合格することを保証します。多くのサイトの中で、どこかのCiscoの350-401復習解答例試験問題集は最も正確性が高いですか。
Cisco 350-401復習解答例 - 。
もし君の予算がちょっと不自由で、おまけに質の良いCiscoの350-401復習解答例試験トレーニング資料を購入したいなら、Goldmile-InfobizのCiscoの350-401復習解答例試験トレーニング資料を選択したほうが良いです。それは値段が安くて、正確性も高くて、わかりやすいです。いろいろな受験生に通用します。あなたはGoldmile-Infobizの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。
最新の資源と最新の動態が第一時間にお客様に知らせいたします。何の問題があったらお気軽に聞いてください。
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
CiscoのNCARB Project-Planning-Designソフトを使用するすべての人を有効にするために最も快適なレビュープロセスを得ることができ、我々は、CiscoのNCARB Project-Planning-Designの資料を提供し、PDF、オンラインバージョン、およびソフトバージョンを含んでいます。 Palo Alto Networks XSIAM-Engineer - 弊社の質問と解答を安心にご利用ください。 改善されているソフトはあなたのCiscoのVMware 2V0-17.25試験の復習の効率を高めることができます。 CiscoのITIL ITIL-4-Specialist-Create-Deliver-and-Support-JPN認定試験は業界で広く認証されたIT認定です。 Lpi 010-160 - 時間が経つとともに、我々はインタネット時代に生活します。
Updated: May 28, 2022