350-401関連資格知識 & 350-401受験対策解説集 - Cisco 350-401無料模擬試験 - Goldmile-Infobiz

今のインタネット時代に当たり、IT人材としてCiscoの350-401関連資格知識資格証明書を取得できないと、大変なことではないなのか?ここで、我が社Goldmile-Infobizは一連の350-401関連資格知識問題集を提供します。あなたは350-401関連資格知識問題集を購入するかどうかと確認したい、Goldmile-Infobizの350-401関連資格知識デーモ版を使用して購入するかと判断します。 それはGoldmile-InfobizのCiscoの350-401関連資格知識試験トレーニング資料を利用することです。これは全てのIT認証試験を受ける受験生のアドバイスです。 受験生のあなたを助けて時間とお金を節約したり、350-401関連資格知識試験に速く合格すると保証します。

CCNP Enterprise 350-401 絶対見逃さないです。

CCNP Enterprise 350-401関連資格知識 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) もしGoldmile-Infobizの学習教材を購入した後、どんな問題があれば、或いは試験に不合格になる場合は、私たちが全額返金することを保証いたします。 もしあなたはGoldmile-Infobizの製品を購入したければ弊社が詳しい問題集を提供して、君にとって完全に準備します。弊社のGoldmile-Infobiz商品を安心に選択してGoldmile-Infobiz試験に100%合格しましょう。

我々Goldmile-Infobizはこの3つを提供します。すべては購入した前で無料でデモをダウンロードできます。ふさわしい方式を選ぶのは一番重要なのです。

Cisco 350-401関連資格知識 - ローマは一日に建てられませんでした。

Goldmile-Infobizが提供したCiscoの350-401関連資格知識の試験トレーニング資料は受験生の皆さんの評判を得たのはもうずっと前のことになります。それはGoldmile-InfobizのCiscoの350-401関連資格知識の試験トレーニング資料は信頼できるもので、確実に受験生を助けて試験に合格するということを証明しました。Goldmile-Infobizが提供したCiscoの350-401関連資格知識の試験トレーニング資料はベストセラーになって、ずっとピアの皆をリードしています。Goldmile-Infobizは消費者の皆さんの許可を得て、評判が良いです。Ciscoの350-401関連資格知識の認証試験を受けたら、速くGoldmile-Infobizというサイトをクッリクしてください。あなたがほしいものを得ることができますから、ミスしないだけで後悔しないです。最も専門的な、最も注目を浴びるIT専門家になりたかったら、速くショッピングカートに入れましょう。

Goldmile-Infobizは認定で優秀なIT資料のウエブサイトで、ここでCisco 350-401関連資格知識認定試験の先輩の経験と暦年の試験の材料を見つけることができるとともに部分の最新の試験の題目と詳しい回答を無料にダウンロードこともできますよ。弊社のIT技術専門家たち は質が高い問題集と答えを提供し、お客様が合格できるように努めています。

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

Goldmile-InfobizのCiscoのCompTIA N10-009問題集と解答はCompTIA N10-009認定試験に一番向いているソフトです。 Microsoft AZ-104 - Goldmile-InfobizはIT試験問題集を提供するウエブダイトで、ここによく分かります。 Fortinet FCSS_SDW_AR-7.4-JPN - Goldmile-Infobizが提供した製品は真実なもので、しかも価格は非常に合理的です。 Goldmile-Infobizが提供したCiscoのSalesforce Sales-101「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。 Goldmile-InfobizのCiscoのMicrosoft SC-300J試験トレーニング資料を選んだらぜひ成功するということを証明しました。

Updated: May 28, 2022