これは人の心によることです。意志が強い人にとって、行動は目と鼻の先にあるのです。あなたはきっとこのような人でしょう。 Goldmile-Infobiz のCiscoの350-401資格認証攻略試験資料はあなたに時間を節約させることができるだけではなく、あなたに首尾よく試験に合格させることもできますから、Goldmile-Infobizを選ばない理由はないです。IT認定試験を受ける受験生はほとんど仕事をしている人です。 Cisco試験の重要なの一環として、350-401資格認証攻略認定試験はあなたに大きな恩恵を与えることができます。
Ciscoの350-401資格認証攻略試験は挑戦がある認定試験です。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格認証攻略問題集を購入する前に、Goldmile-Infobizに行ってより多くの情報を読んでください。 逆境は人をテストすることができます。困難に直面するとき、勇敢な人だけはのんびりできます。
Goldmile-Infobizはあなたが必要とするすべての350-401資格認証攻略参考資料を持っていますから、きっとあなたのニーズを満たすことができます。Goldmile-Infobizのウェブサイトに行ってもっとたくさんの情報をブラウズして、あなたがほしい試験350-401資格認証攻略参考書を見つけてください。350-401資格認証攻略認定試験の資格を取得するのは容易ではないことは、すべてのIT職員がよくわかっています。
弊社のCisco 350-401資格認証攻略問題集は三種類の版を提供いたします。
Ciscoの350-401資格認証攻略試験は国際的に認可られます。これがあったら、よい高い職位の通行証を持っているようです。Goldmile-Infobizの提供するCiscoの350-401資格認証攻略試験の資料とソフトは経験が豊富なITエリートに開発されて、何回も更新されています。何十ユーロだけでこのような頼もしいCiscoの350-401資格認証攻略試験の資料を得ることができます。試験に合格してからあなたがよりよい仕事と給料がもらえるかもしれません。
キャンパース内のIT知識を学ぶ学生なり、IT職人なり、350-401資格認証攻略試験資格認証証明書を取得して、社会需要に応じて自分の能力を高めます。我々社は最高のCisco 350-401資格認証攻略試験問題集を開発し提供して、一番なさービスを与えて努力しています。
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
我々社は最高のCisco ISA ISA-IEC-62443試験問題集を開発し提供して、一番なさービスを与えて努力しています。 弊社は量豊かのIT試験資料を所有するから、あなたは別のCisco Amazon SAA-C03試験に関心を寄せるなら、Goldmile-Infobizでは需要したい資料を尋ねたり、弊社の職員に問い合わせたりしています。 Cisco Medical Tests PTCE資格認定はIT技術領域に従事する人に必要があります。 だから、我々社の有効な試験問題集は長年にわたりCisco Palo Alto Networks XSIAM-Engineer認定資格試験問題集作成に取り組んだIT専門家によって書いてます。 そのいくつの点で、Amazon AWS-Developer試験に合格することを保障できます。
Updated: May 28, 2022