Goldmile-Infobizを選択したら、成功が遠くではありません。Goldmile-Infobizが提供するCiscoの350-401資格認証攻略認証試験問題集が君の試験に合格させます。テストの時に有効なツルが必要でございます。 もちろん、いいサービスを提供し、350-401資格認証攻略参考資料について、何か質問がありましたら、遠慮なく弊社と連絡します。今まで、たくさんのお客様はCisco 350-401資格認証攻略試験参考資料に満足しています。 Ciscoの350-401資格認証攻略認定試験を受けることを決めたら、Goldmile-Infobizがそばにいて差し上げますよ。
CCNP Enterprise 350-401 成功の楽園にどうやって行きますか。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格認証攻略認定試験は専門知識と情報技術を検査する試験で、Goldmile-Infobizが一日早くCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格認証攻略認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」に合格させるのサイトで試験の前に弊社が提供する訓練練習問題をテストして、短い時間であなたの収穫が大きいです。 優秀な試験参考書は話すことに依頼することでなく、受験生の皆さんに検証されることに依頼するのです。Goldmile-Infobizの参考資料は時間の試練に耐えることができます。
Goldmile-Infobizはこの問題を着々解決できますよ。IT専門家がCiscoの350-401資格認証攻略認定試験に関する特別な問題集を開発しています。それをもって、試験は問題になりませんよ。
Cisco 350-401資格認証攻略 - ふさわしい方式を選ぶのは一番重要なのです。
Goldmile-InfobizのCiscoの350-401資格認証攻略試験トレーニング資料は受験生が模擬試験場で勉強させます。受験生は問題を選べ、テストの時間もコントロールできます。Goldmile-Infobizというサイトで、あなたはストレスと不安なく試験の準備をすることができますから、一般的な間違いを避けられます。そうしたら、あなたは自信を得ることができて、実際の試験で経験を活かして気楽に合格します。
このサービスは無料なのです。あなたが我々の資料を購入するとき、あなたのCiscoの350-401資格認証攻略試験に関するすべてのヘルプを購入しました。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
Huawei H13-624_V5.5 - Goldmile-Infobizのトレーニング資料は実践の検証に合格すたもので、多くの受験生に証明された１００パーセントの成功率を持っている資料です。 弊社のCiscoのMicrosoft SC-401J真題によって、資格認定証明書を受け取れて、仕事の昇進を実現できます。 CompTIA N10-009J - このトレーニング方法は受験生の皆さんに短い時間で予期の成果を取らせます。 弊社のASQ CSSBBソフト版問題集はかねてより多くのIT事業をしている人々は順調にCisco ASQ CSSBB資格認定を取得させます。 ISACA CRISC - そうですか。
Updated: May 28, 2022