Goldmile-Infobiz에서는 가장 최신이자 최고인Cisco인증 350-401시험내용시험덤프를 제공해드려 여러분이 IT업계에서 더 순조롭게 나아가도록 최선을 다해드립니다. Cisco인증 350-401시험내용덤프는 최근 실제시험문제를 연구하여 제작한 제일 철저한 시험전 공부자료입니다. Cisco인증 350-401시험내용시험준비자료는 Goldmile-Infobiz에서 마련하시면 기적같은 효과를 안겨드립니다. Goldmile-Infobiz 는 인증시험에 참가하는 분들한테 편리를 제공하는 사이트이며,여러분들이 시험패스에 도움을 줄 수 있는 사이트입니다. Cisco 350-401시험내용인증시험을 패스하려면 시험대비자료선택은 필수입니다. 자신을 부단히 업그레이드하려면 많은 노력이 필요합니다.
CCNP Enterprise 350-401 Goldmile-Infobiz는 믿을 수 있는 사이트입니다.
CCNP Enterprise 350-401시험내용 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 왜냐면 우리의 전문가들은 매일 최신버전을 갱신하고 있기 때문입니다. Cisco 350-401 시험응시 덤프는 pdf버전,테스트엔진버전, 온라인버전 세가지 버전의 파일로 되어있습니다. pdf버전은 반드시 구매하셔야 하고 테스트엔진버전과 온라인버전은 pdf버전 구매시 추가구매만 가능합니다.
여러분이 어떤 업계에서 어떤 일을 하든지 모두 항상 업그레이되는 자신을 원할 것입니다.,it업계에서도 이러합니다.모두 자기자신의 업그레이는 물론 자기만의 공간이 있기를 바랍니다.전문적인 IT인사들은 모두 아시다싶이Cisco 350-401시험내용인증시험이 여러분의 이러한 요구를 만족시켜드립니다.그리고 우리 Goldmile-Infobiz는 이러한 꿈을 이루어드립니다.
Cisco 350-401시험내용 - IT업계에 종사하시는 분들은 IT인증시험을 통한 자격증취득의 중요성을 알고 계실것입니다.
350-401시험내용는Cisco의 인증시험입니다.350-401시험내용인증시험을 패스하면Cisco인증과 한 발작 더 내디딘 것입니다. 때문에350-401시험내용시험의 인기는 날마다 더해갑니다.350-401시험내용시험에 응시하는 분들도 날마다 더 많아지고 있습니다. 하지만350-401시험내용시험의 통과 율은 아주 낮습니다.350-401시험내용인증시험준비중인 여러분은 어떤 자료를 준비하였나요?
Goldmile-Infobiz에서 출시한 Cisco인증350-401시험내용덤프는 이미 사용한 분들에게 많은 호평을 받아왔습니다. 시험적중율 최고에 많은 공부가 되었다고 희소식을 전해올때마다 Goldmile-Infobiz는 더욱 완벽한Cisco인증350-401시험내용시험덤프공부자료로 수정하고기 위해 최선을 다해왔습니다.
350-401 PDF DEMO:
QUESTION NO: 1
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
Goldmile-Infobiz는 유일하게 여러분이 원하는Cisco인증Microsoft MB-800시험관련자료를 해결해드릴 수 잇는 사이트입니다. SAP C_BCBAI_2502 - 업데이트가능하면 바로 업데이트하여 업데이트된 최신버전을 무료로 제공해드리는데 시간은 1년동안입니다. Goldmile-Infobiz는Cisco Esri EAEP_2025시험을 패스할 수 있는 아주 좋은 사이트입니다. Cisco인증 Cisco 700-242시험에서 떨어지는 경우Cisco인증 Cisco 700-242덤프비용전액 환불신청을 할수 있기에 보장성이 있습니다.시험적중율이 떨어지는 경우 덤프를 빌려 공부한 것과 같기에 부담없이 덤프를 구매하셔도 됩니다. Cisco 300-535 - 1년 무료 업데이트서비스를 제공해드리기에 시험시간을 늦추어도 시험성적에 아무런 페를 끼치지 않습니다.
Updated: May 28, 2022