많은 사이트에서도 무료Cisco 350-401 Dumps덤프데모를 제공합니다.우리도 마찬가지입니다.여러분은 그러한Cisco 350-401 Dumps데모들을 보시고 다시 우리의 덤프와 비교하시면 ,우리의 덤프는 다른 사이트덤프와 차원이 다른 덤프임을 아시될것입니다, 우리Goldmile-Infobiz에서 제공되는 덤프는 100%보장 도를 자랑하며,여러분은 시험패스로 인해 성공과 더 가까워 졌답니다 Goldmile-Infobiz는 100%한번에Cisco 350-401 Dumps이장시험을 패스할 것을 보장하며 우리가 제공하는 문제와 답을 시험에서 백프로 나올 것입니다.여러분이Cisco 350-401 Dumps시험에 응시하여 우리의 도움을 받는다면 Goldmile-Infobiz에서는 꼭 완벽한 자료를 드릴 것을 약속합니다. 또한 일년무료 업데이트서비스를 제공합니다.즉 문제와 답이 갱신이 되었을 경우 우리는 여러분들한테 최신버전의 문제와 답을 다시 보내드립니다. 350-401 Dumps인증시험은Cisco사의 인중시험입니다.Cisco인증사의 시험을 패스한다면 it업계에서의 대우는 달라집니다.
CCNP Enterprise 350-401 아니 거이 같습니다.
CCNP Enterprise 350-401 Dumps - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 우리는 100%시험패스를 보장하고 또 일년무료 업데이트서비스를 제공합니다. 안심하시고 우리 Goldmile-Infobiz가 제공하는 알맞춤 문제집을 사용하시고 완벽한Cisco 350-401 예상문제인증시험 준비를 하세요. Goldmile-Infobiz연구한 전문Cisco 350-401 예상문제인증시험을 겨냥한 덤프가 아주 많은 인기를 누리고 있습니다.
Cisco인증350-401 Dumps시험은 IT인증시험과목중 가장 인기있는 시험입니다. Goldmile-Infobiz에서는Cisco인증350-401 Dumps시험에 대비한 공부가이드를 발췌하여 IT인사들의 시험공부 고민을 덜어드립니다. Goldmile-Infobiz에서 발췌한 Cisco인증350-401 Dumps덤프는 실제시험의 모든 범위를 커버하고 있고 모든 시험유형이 포함되어 있어 시험준비 공부의 완벽한 선택입니다.
Cisco 350-401 Dumps - Goldmile-Infobiz시험공부자료를 선택하시면 자격증취득의 소원이 이루어집니다.
Goldmile-Infobiz는 많은 분들이 IT인증시험을 응시하여 성공하도록 도와주는 사이트입니다. Goldmile-Infobiz 의 덤프는 모두 엘리트한 전문가들이 만들어낸 만큼 시험문제의 적중률은 아주 높습니다. 거의 100%의 정확도를 자랑하고 있습니다. 아마 많은 유사한 사이트들도 많습니다. 이러한 사이트에서 학습가이드와 온라인서비스도 지원되고 있습니다만 Goldmile-Infobiz 는 이미 이러한 사이트를 뛰어넘은 실력으로 업계에서 우리만의 이미지를 지키고 있습니다. Goldmile-Infobiz 는 정확한 문제와 답만 제공하고 또한 그 어느 사이트보다도 빠른 업데이트로 여러분의 인증시험을 안전하게 패스하도록 합니다.
많은 사이트에서 Cisco인증 350-401 Dumps시험대비덤프를 제공해드리는데Goldmile-Infobiz를 최강 추천합니다. Goldmile-Infobiz의Cisco인증 350-401 Dumps덤프에는 실제시험문제의 기출문제와 예상문제가 수록되어있어 그 품질 하나 끝내줍니다.적중율 좋고 가격저렴한 고품질 덤프는Goldmile-Infobiz에 있습니다.
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
Splunk SPLK-4001 - Goldmile-Infobiz에서 덤프를 마련하여 자격증취득에 도전하여 인생을 바꿔보세요. Cisco인증 Pennsylvania Real Estate Commission RePA_Sales_S시험준비자료는 Goldmile-Infobiz에서 마련하시면 기적같은 효과를 안겨드립니다. Cisco인증 Juniper JN0-232시험을 어떻게 패스할가 고민그만하고Goldmile-Infobiz의Cisco 인증Juniper JN0-232시험대비 덤프를 데려가 주세요.가격이 착한데 비해 너무나 훌륭한 덤프품질과 높은 적중율, Goldmile-Infobiz가 아닌 다른곳에서 찾아볼수 없는 혜택입니다. Cisco인증 Google Associate-Cloud-Engineer시험이 어려워 자격증 취득을 망설이는 분들이 많습니다. Goldmile-Infobiz의 Cisco CIPS L5M6덤프는 Cisco CIPS L5M6시험문제변경에 따라 주기적으로 업데이트를 진행하여 덤프가 항상 가장 최신버전이도록 업데이트를 진행하고 있습니다.구매한 Cisco CIPS L5M6덤프가 업데이트되면 저희측에서 자동으로 구매시 사용한 메일주소에 업데이트된 최신버전을 발송해드리는데 해당 덤프의 구매시간이 1년미만인 분들은 업데이트서비스를 받을수 있습니다.
Updated: May 28, 2022