여러분은 우선 우리 Goldmile-Infobiz사이트에서 제공하는Cisco인증350-401인기덤프자료시험덤프의 일부 문제와 답을 체험해보세요. 우리 Goldmile-Infobiz를 선택해주신다면 우리는 최선을 다하여 여러분이 꼭 한번에 시험을 패스할 수 있도록 도와드리겠습니다.만약 여러분이 우리의 인증시험덤프를 보시고 시험이랑 틀려서 패스를 하지 못하였다면 우리는 무조건 덤프비용전부를 환불해드립니다. Goldmile-Infobiz 덤프의 문제와 답은 모두 제일 정확합니다. 왜냐면 우리의 전문가들은 매일 최신버전을 갱신하고 있기 때문입니다. 혹은 여러분은 전문적인 IT관련지식을 터득하자들보다 더 간단히 더 빨리 시험을 패스하실 수 있습니다.
CCNP Enterprise 350-401 체험 후 우리의Goldmile-Infobiz에 신뢰감을 느끼게 됩니다.
Cisco인증350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)인기덤프자료시험은Goldmile-Infobiz 표Cisco인증350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)인기덤프자료덤프자료로 시험준비를 하시면 시험패스는 아주 간단하게 할수 있습니다. Goldmile-Infobiz 에서 제공해드리는 Cisco 350-401 공부자료덤프는 아주 우수한 IT인증덤프자료 사이트입니다. IT업계엘리트한 강사들이 퍼펙트한 Cisco 350-401 공부자료 덤프문제집을 제작하여 디테일한 시험문제와 답으로 여러분이 아주 간단히Cisco 350-401 공부자료시험을 패스할 수 있도록 최선을 다하고 있습니다.
IT자격증을 많이 취득하여 IT업계에서 자신만의 단단한 자리를 보장하는것이 여러분들의 로망이 아닐가 싶습니다. Goldmile-Infobiz의 완벽한 Cisco인증 350-401인기덤프자료덤프는 IT전문가들이 자신만의 노하우와 경험으로 실제Cisco인증 350-401인기덤프자료시험문제에 대비하여 연구제작한 완벽한 작품으로서 100%시험통과율을 보장합니다.
Cisco인증 Cisco 350-401인기덤프자료시험은 인기자격증을 취득하는데 필요한 시험과목입니다.
Goldmile-Infobiz의 Cisco인증 350-401인기덤프자료시험덤프는 실제시험의 기출문제와 예상문제를 묶어둔 공부자료로서 시험문제커버율이 상당히 높습니다.IT업계에 계속 종사하려는 IT인사들은 부단히 유력한 자격증을 취득하고 자신의 자리를 보존해야 합니다. Goldmile-Infobiz의 Cisco인증 350-401인기덤프자료시험덤프로 어려운 Cisco인증 350-401인기덤프자료시험을 쉽게 패스해보세요. IT자격증 취득이 여느때보다 여느일보다 쉬워져 자격증을 많이 따는 꿈을 실현해드립니다.
Cisco인증 350-401인기덤프자료시험을 등록하였는데 시험준비를 어떻게 해애 될지 몰라 고민중이시라면 이 글을 보고Goldmile-Infobiz를 찾아주세요. Goldmile-Infobiz의Cisco인증 350-401인기덤프자료덤프샘플을 체험해보시면 시험에 대한 두려움이 사라질것입니다.
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
ASQ CMQ-OE - Goldmile-Infobiz덤프공부자료는 엘리트한 IT전문자들이 자신의 노하우와 경험으로 최선을 다해 연구제작한 결과물입니다.IT인증자격증을 취득하려는 분들의 곁은Goldmile-Infobiz가 지켜드립니다. Cisco Network Appliance NS0-005 덤프는 Cisco Network Appliance NS0-005 시험의 모든 문제를 커버하고 있어 시험적중율이 아주 높습니다. 그건 바로Goldmile-Infobiz의Cisco인증 Cisco 300-535덤프로Cisco인증 Cisco 300-535시험에 대비하는것입니다. 아직도Cisco Salesforce Plat-101 인증시험을 어떻게 패스할지 고민하시고 계십니까? Goldmile-Infobiz는 여러분이Cisco Salesforce Plat-101덤프자료로Cisco Salesforce Plat-101 인증시험에 응시하여 안전하게 자격증을 취득할 수 있도록 도와드립니다. Cisco 인증IIA IIA-CIA-Part3 도 여러분의 무용지물이 아닌 아주 중요한 자료가 되리라 믿습니다.
Updated: May 28, 2022