あなたは勇敢な人ですか。もしIT認証の準備をしなかったら、あなたはのんびりできますか。もちろんです。 Ciscoの350-401出題内容資格認定証明書を持つ人は会社のリーダーからご格別のお引き立てを賜ったり、仕事の昇進をたやすくなったりしています。これなので、今から我々社Goldmile-Infobizの350-401出題内容試験に合格するのに努力していきます。 Goldmile-Infobizへ来てあなたがほしいヘルパーと試験の準備ツールを見つけることができますから。
CCNP Enterprise 350-401 弊社は1年間の無料更新サービスを提供いたします。
Goldmile-Infobizの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)出題内容問題集はあなたの一発合格を保証できる資料です。 誠意をみなぎるCisco 350-401 全真模擬試験試験備考資料は我々チームの専業化を展示されるし、最完全の質問と再詳細の解説でもって試験に合格するのを助けるます。同時的に、皆様の認可は我々仕事の一番良い評価です。
Goldmile-Infobizの問題集は100％の合格率を持っています。Goldmile-Infobizの350-401出題内容問題集は多くのIT専門家の数年の経験の結晶で、高い価値を持っています。その350-401出題内容参考資料はIT認定試験の準備に使用することができるだけでなく、自分のスキルを向上させるためのツールとして使えることもできます。
彼らにCiscoのCisco 350-401出題内容試験に合格させました。
Goldmile-Infobizは客様の要求を満たせていい評判をうけいたします。たくさんのひとは弊社の商品を使って、試験に順調に合格しました。そして、かれたちがリピーターになりました。Goldmile-Infobizが提供したCiscoの350-401出題内容試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。
試験に合格してからあなたがよりよい仕事と給料がもらえるかもしれません。Ciscoの350-401出題内容試験は国際的に認可られます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
今の人材が多い社会中に多くの業界は人材不足でたとえばIT業界はかなり技術的な人材が不足で、CiscoのSalesforce Analytics-Admn-201認定試験はIT技術の認証試験の1つで、Goldmile-InfobizはCiscoのSalesforce Analytics-Admn-201認証試験に関するの特別な技術を持ってサイトでございます。 Juniper JN0-460 - 今の社会はますます激しく変化しているから、私たちはいつまでも危機意識を強化します。 Huawei H11-861_V4.0 - 真実試験問題が似てるのを確保することができて一回合格するのは目標にしています。 あなたの取得したCisco ISACA CISA-KR資格認定は、仕事中に核心技術知識を同僚に認可されるし、あなたの技術信頼度を増強できます。 SAP C_S4CS_2508 - Goldmile-Infobizが提供した研修ツールが対応性的なので君の貴重な時間とエネルギーを節約できます。
Updated: May 28, 2022