この資料は問題と解答に含まれていて、実際の試験問題と殆ど同じで、最高のトレーニング資料とみなすことができます。人々はそれぞれ自分の人生計画があります。違った選択をしたら違った結果を取得しますから、選択は非常に重要なことです。 Ciscoの350-401勉強時間試験に関する権威のある学習教材を見つけないで、悩んでいますか？世界中での各地の人々はほとんどCiscoの350-401勉強時間試験を受験しています。Ciscoの350-401勉強時間の認証試験の高品質の資料を提供しているユニークなサイトはGoldmile-Infobizです。 Goldmile-Infobizを利用したら、あなたは楽に試験に受かることができます。
だから、弊社の350-401勉強時間練習資料を早く購入しましょう！
CCNP Enterprise 350-401勉強時間 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 業界のリーダーとなっているために、我々は確かに独自のリソースを拡大し続ける必要があります。 今競争の激しいIT業界で地位を固めたいですが、Cisco 350-401 出題内容認証試験に合格しなければなりません。IT業界ではさらに強くなるために強い専門知識が必要です。
競争の中で排除されないように、あなたはCiscoの350-401勉強時間試験に合格しなければなりません。たくさんの時間と精力で試験に合格できないという心配な心情があれば、我々Goldmile-Infobizにあなたを助けさせます。多くの受験生は我々のソフトでCiscoの350-401勉強時間試験に合格したので、我々は自信を持って我々のソフトを利用してあなたはCiscoの350-401勉強時間試験に合格する保障があります。
Cisco 350-401勉強時間問題集の特徴は便利で使い安いです。
Goldmile-InfobizのCiscoの350-401勉強時間試験トレーニング資料は全てのオンラインのトレーニング資料で一番よいものです。我々の知名度はとても高いです。これは受験生の皆さんが資料を利用した後の結果です。Goldmile-InfobizのCiscoの350-401勉強時間試験トレーニング資料を選んだら、１００パーセントの成功率を保証します。もし失敗だったら、我々は全額で返金します。受験生の皆さんの重要な利益が保障できるようにGoldmile-Infobizは絶対信頼できるものです。
おそらく、君たちは私たちの350-401勉強時間試験資料について何も知らないかもしれません。でも、私たちの350-401勉強時間試験資料のデモをダウンロードしてみると、全部わかるようになります。
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Goldmile-InfobizのCiscoのSAP C_BCBAI_2509「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料はIT職員としてのあなたがIT試験に受かる不可欠なトレーニング資料です。 Goldmile-InfobizはCiscoのMicrosoft AZ-900-JPNの認定試験の受験生にとっても適合するサイトで、受験生に試験に関する情報を提供するだけでなく、試験の問題と解答をはっきり解説いたします。 これは間違いなくあなたがMicrosoft GH-300-JPN認定試験に合格することを保証できる問題集です。 Cisco 350-501 - Goldmile-Infobizが提供した問題集を使用してIT業界の頂点の第一歩としてとても重要な地位になります。 APICS CSCP-KR - この認証資格はあなたの仕事にたくさんのメリットを与えられ、あなたの昇進にも助けになることができます。
Updated: May 28, 2022