我々は多くの受験生にCiscoの350-401実際試験試験に合格させたことに自慢したことがないのです。IT業界での競争が激しいですから、我々は発展のために改善し続けなければなりません。だから、我々の専門家たちはタイムリーにCiscoの350-401実際試験資料を更新していて、我々の商品を利用している受験生にCiscoの350-401実際試験試験の変革とともに進めさせます。 君は他の人の一半の努力で、同じCiscoの350-401実際試験認定試験を簡単に合格できます。Goldmile-Infobizはあなたと一緒に君のITの夢を叶えるために頑張ります。 我々350-401実際試験試験真題を暗記すれば、あなたはこの試験にパースすることができます。
彼らにCiscoの350-401実際試験試験に合格させました。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)実際試験試験備考資料の整理を悩んでいますか。 何十ユーロだけでこのような頼もしいCiscoの350-401 問題と解答試験の資料を得ることができます。試験に合格してからあなたがよりよい仕事と給料がもらえるかもしれません。
だから、Goldmile-InfobizはあなたがCisco 350-401実際試験資格認定試験にパースする正確の方法です。まだどうのようにCisco 350-401実際試験資格認定試験にパースすると煩悩していますか。現時点で我々サイトGoldmile-Infobizを通して、ようやくこの問題を心配することがありませんよ。
Cisco 350-401実際試験 - 迷ってないください。
Goldmile-Infobizの問題集はIT専門家がCiscoの350-401実際試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験について自分の知識と経験を利用して研究したものでございます。Goldmile-Infobizの問題集は真実試験の問題にとても似ていて、弊社のチームは自分の商品が自信を持っています。Goldmile-Infobizが提供した商品をご利用してください。もし失敗したら、全額で返金を保証いたします。
それに、Ciscoの350-401実際試験の試験の実践経験やテストダンプにも含まれています。Goldmile-Infobizは受験生たちを助けて試験の準備をして、試験に合格するサイトですから、受験生のトレーニングにいろいろな便利を差し上げます。
350-401 PDF DEMO:
QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
ITIL ITIL-4-Foundation-JPN - 弊社が提供したすべての勉強資料と他のトレーニング資料はコスト効率の良い製品で、サイトが一年間の無料更新サービスを提供します。 Goldmile-InfobizのCiscoのServiceNow CAD問題集を買う前に、一部の問題と解答を無料に試用することができます。 ISACA CRISC - その理由でこの試験はますます重視されるになります。 HITRUST CCSFP - Goldmile-Infobizには専門的なエリート団体があります。 でも、試験に合格するために大量な時間とエネルギーを費やすことはなく、Goldmile-InfobizのCiscoのAmazon AIF-C01-JPN試験トレーニング資料を選んだらいいです。
Updated: May 28, 2022