二つのバージョンのどちらでもダウンロードできますから、Goldmile-Infobizのサイトで検索してダウンロードすることができます。体験してから購入するかどうかを決めてください。そうすると、350-401予想試験問題集の品質を知らないままに問題集を購入してから後悔になることを避けることができます。 Cisco 350-401予想試験認証試験に合格することが簡単ではなくて、Cisco 350-401予想試験証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 IT試験に順調に合格することを望むなら、Goldmile-Infobizの350-401予想試験問題集を使用する必要があります。
CCNP Enterprise 350-401 それに、あなたに極大な便利と快適をもたらせます。
Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)予想試験試験が更新するとともに我々の作成するソフトは更新しています。 近年、IT業種の発展はますます速くなることにつれて、ITを勉強する人は急激に多くなりました。人々は自分が将来何か成績を作るようにずっと努力しています。
我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。Ciscoの350-401予想試験の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoの350-401予想試験試験に一番信頼できるヘルプを提供します。Ciscoの350-401予想試験試験に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。
Cisco 350-401予想試験 - 人生には様々な選択があります。
Ciscoの350-401予想試験試験に趣味があると、躊躇わなく、我々Goldmile-Infobizで問題集のデーモをダウンロードして試すことができます。デーモ版によって、この350-401予想試験問題集はあなたに適合するかと判断します。適合すると、あなたは安心で購買できます。弊社Goldmile-Infobizの350-401予想試験問題集は必ずあなたの成功へ道の秘訣です。
このような保証があれば、Goldmile-Infobizの350-401予想試験問題集を購入しようか購入するまいかと躊躇する必要は全くないです。この問題集をミスすればあなたの大きな損失ですよ。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
我々の希望は誠意と専業化を感じられることですなので、お客様に無料のCisco Amazon DOP-C02-KR問題集デモを提供します。 USGBC LEED-Green-Associate-KR - この認証資格はあなたの仕事にたくさんのメリットを与えられ、あなたの昇進にも助けになることができます。 我々社の練習問題は長年でCisco 350-401全真模擬試験トレーニング資料に研究している専業化チームによって編集されます。 Amazon AIF-C01-KR - ですから、君はうちの学習教材を安心で使って、きみの認定試験に合格することを保証します。 Cisco HP HPE6-A87試験参考書に疑問を持たれば、Cisco会社のウエブサイトから無料でHP HPE6-A87試験のためのデモをダウンロードできます。
Updated: May 28, 2022