弊社の商品は試験の範囲を広くカバーすることが他のサイトがなかなか及ばならないです。それほかに品質はもっと高くてCiscoの350-401模擬対策問題認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の受験生が最良の選択であり、成功の最高の保障でございます。 Cisco 350-401模擬対策問題試験のための一切な需要を満足して努力します。購入した後、我々はあなたが350-401模擬対策問題試験にうまく合格するまで細心のヘルプをずっと与えます。 弊社が提供した問題集がほかのインターネットに比べて問題のカーバ範囲がもっと広くて対応性が強い長所があります。
CCNP Enterprise 350-401 成功の楽園にどうやって行きますか。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬対策問題認定試験は専門知識と情報技術を検査する試験で、Goldmile-Infobizが一日早くCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬対策問題認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」に合格させるのサイトで試験の前に弊社が提供する訓練練習問題をテストして、短い時間であなたの収穫が大きいです。 Goldmile-Infobizは現在の実績を持っているのは受験生の皆さんによって実践を通して得られた結果です。真実かつ信頼性の高いものだからこそ、Goldmile-Infobizの試験参考書は長い時間にわたってますます人気があるようになっています。
それをもって、試験は問題になりませんよ。Ciscoの350-401模擬対策問題認定試験がIT業界には極めて重要な地位があるがよく分かりましょう。試験に合格するのは簡単ではないもよくわかりましょう。
Cisco 350-401模擬対策問題 - こうして、君は安心で試験の準備を行ってください。
私たちは、Goldmile-InfobizのCiscoの350-401模擬対策問題問題集を使ったら、初めて認定試験を受ける君でも一回で試験に合格することができるということを保証します。もし認定試験に失敗したら、或いは学習教材は問題があれば、私たちは全額返金することを保証いたします。そして、Goldmile-InfobizのCiscoの350-401模擬対策問題問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。
Goldmile-Infobizが提供したCiscoの350-401模擬対策問題「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Goldmile-InfobizのCiscoのMicrosoft AZ-800J試験トレーニング資料は正確性が高くて、カバー率も広いです。 Microsoft PL-300-KR - Goldmile-Infobizは素早く君のCisco試験に関する知識を補充できて、君の時間とエネルギーが節約させるウェブサイトでございます。 うちのCiscoのAmazon SAA-C03試験トレーニング資料は正確性が高くて、カバー率も広いで、君がCiscoのAmazon SAA-C03認定試験に合格するのに大変役に立ちます。 Goldmile-Infobizは異なるトレーニングツールと資源を提供してあなたのCiscoのACAMS CAMS-JPの認証試験の準備にヘルプを差し上げます。 多くの人はCiscoのPing Identity PAP-001試験への準備に悩んでいます。
Updated: May 28, 2022