350-401참고자료 - Cisco 350-401 Vce - Implementing Cisco Enterprise Network Core Technologies 350-401 Encor - Goldmile-Infobiz

Cisco인증 350-401참고자료시험패스 공부방법을 찾고 있다면 제일 먼저Goldmile-Infobiz를 추천해드리고 싶습니다. Cisco인증 350-401참고자료시험이 많이 어렵다는것은 모두 알고 있는 것입니다. Goldmile-Infobiz에서 출시한 Cisco인증 350-401참고자료덤프는 실제시험을 대비하여 연구제작된 멋진 작품으로서 Cisco인증 350-401참고자료시험적중율이 최고입니다. Goldmile-Infobiz 의 학습가이드에는Cisco 350-401참고자료인증시험의 예상문제, 시험문제와 답 임으로 100% 시험을 패스할 수 있습니다.우리의Cisco 350-401참고자료시험자료로 충분한 시험준비하시는것이 좋을것 같습니다. 그리고 우리는 일년무료 업데이트를 제공합니다. Cisco인증 350-401참고자료시험을 통과하여 자격증을 취득하려면Goldmile-Infobiz의 Cisco인증 350-401참고자료덤프로 시험준비공부를 하세요.

CCNP Enterprise 350-401 환불해드린후에는 무료업데이트 서비스가 종료됩니다.

Cisco인증350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)참고자료시험은 현재 치열한 IT경쟁 속에서 열기는 더욱더 뜨겁습니다. Goldmile-Infobiz에서 Cisco 350-401 인기덤프 덤프를 다운받아 공부하시면 가장 적은 시간만 투자해도Cisco 350-401 인기덤프시험패스하실수 있습니다. Goldmile-Infobiz에서Cisco 350-401 인기덤프시험덤프를 구입하시면 퍼펙트한 구매후 서비스를 제공해드립니다.

Goldmile-Infobiz에서 제공해드리는Cisco 인증 350-401참고자료시험대비 덤프는 덤프제공사이트에서 가장 최신버전이여서 시험패스는 한방에 갑니다. Cisco 인증 350-401참고자료시험뿐만 아니라 IT인증시험에 관한 모든 시험에 대비한 덤프를 제공해드립니다. 많은 애용 바랍니다.

우리의Cisco Cisco 350-401참고자료자료로 자신만만한 시험 준비하시기를 바랍니다.

Cisco인증 350-401참고자료시험은 인기있는 IT자격증을 취득하는데 필요한 국제적으로 인정받는 시험과목입니다. Cisco인증 350-401참고자료시험을 패스하려면 Goldmile-Infobiz의Cisco인증 350-401참고자료덤프로 시험준비공부를 하는게 제일 좋은 방법입니다. Goldmile-Infobiz덤프는 IT전문가들이 최선을 다해 연구해낸 멋진 작품입니다. Cisco인증 350-401참고자료덤프구매후 업데이트될시 업데이트버전을 무료서비스료 제공해드립니다.

우리Goldmile-Infobiz에서는 끊임없는 업데이트로 항상 최신버전의Cisco인증350-401참고자료시험덤프를 제공하는 사이트입니다, 만약 덤프품질은 알아보고 싶다면 우리Goldmile-Infobiz 에서 무료로 제공되는 덤프일부분의 문제와 답을 체험하시면 되겠습니다, Goldmile-Infobiz 는 100%의 보장 도를 자랑하며350-401참고자료시험은 한번에 패스할 수 있는 덤프입니다.

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

Goldmile-Infobiz에서 출시한 Cisco인증 SAP C_ARCON_2508덤프는 IT인사들이 자격증 취득의 험난한 길에서 없어서는 안될중요한 존재입니다. 그래야 여러분은 빨리 한번에Cisco인증Microsoft GH-900시험을 패스하실 수 있습니다.Cisco인증Microsoft GH-900관련 최고의 자료는 현재까지는Goldmile-Infobiz덤프가 최고라고 자신 있습니다. 시험문제가 변경되면 업데이트 하도록 최선을 다하기에Goldmile-Infobiz의 Cisco인증 HP HPE7-A03덤프의 유효기간을 연장시켜드리는 셈입니다.퍼펙트한 구매후는 서비스는Goldmile-Infobiz의 Cisco인증 HP HPE7-A03덤프를 구매하시면 받을수 있습니다. 우리Goldmile-Infobiz 사이트에Cisco WGU Secure-Software-Design관련자료의 일부 문제와 답 등 문제들을 제공함으로 여러분은 무료로 다운받아 체험해보실 수 있습니다. SAP C-TS422-2504 - Goldmile-Infobiz에서는 IT인증시험에 대비한 모든 덤프자료를 제공해드립니다.

Updated: May 28, 2022